But ntfs-3g installation may provide following error in your terminal: Error: Could not symlink sbin/ntfs-3g usr/local/sbin is not writable. If you don’t see any error / warnings you can just proceed to Step-4 skipping the rest of this step. Then install ntfs-3g: brew install ntfs-3gģ. Install osxfuse using homebrew with following command in your Terminal: brew cask install osxfuse In your Terminal then we are good to go for the next steps:Ģ. System Integrity Protection status: disabled. Open the Terminal to check if the system integrity status is disabled using this command: csrutil status Now reboot your Mac again and and let it boot normally. Open up the Terminal from the “Utilities” menu and type in the following: csrutil disable Reboot the Mac and hold Command+R at boot to get into the recovery console. We need to disable the system integrity protection first.

You can install Homebrew pasting following command in your Terminal: /usr/bin/ruby -e '$(curl -fsSL )' Stepsġ.

Enable NTFS write support in MacOS High Sierra (10.13.x) Prerequisiteīefore you begin, make sure Homebrew is installed on your current system.

How to write to ntfs on mac sierra